What are the things to pay attention to when cleaning and sterilizing the Oxygen zirconium ceramic filling pump?
⑴. When cleaning and sterilizing (oxidation) zirconium ceramic filling pumps (fungus), chemical solutions containing chlorine must not be used in contact with stainless steel to prevent corrosion of stainless steel parts.
⑵. When cleaning and sterilizing the zirconia ceramic (raw material: non-metallic mineral) filling pump, the ceramic metering parts must not be pulled in hot water exceeding 40℃. Maintenance workers need to perform daily maintenance on the machine's electric oil pump, centralized oil supply, heat dissipation parts of the main motor, input shaft of the open cam box, electromagnetic brake, weft finder, scissors, edge hems, temple supports and edge catching yarn. The ceramic plunger and ceramic sleeve should be cleaned separately.
⑶ When cleaning and sterilizing the Oxygen zirconium ceramic filling pump, the rotary valve, ceramic sleeve, and metering rod should be placed separately in a special sterilization box. Hang the ceramic rod and ceramic sleeve vertically for moist heat sterilization to prevent thermal deformation and folding; after sterilization, the temperature of each component should naturally drop to room temperature before installation and operation control can be carried out. Before the temperature of the pump body drops to room temperature, avoid Sudden cooling causes damage to various components. Air-jet loom auxiliary nozzle maintenance workers need to inspect the machine's electric oil pump, centralized oil supply, main motor heat dissipation parts, input shaft of the opening cam box, electromagnetic brake, weft finder, scissors, twisted edge, temple support and edge catching processing yarn. Routine maintenance.
(4) Oxygen zirconium ceramic is harder than metal. Contact between zirconium oxide ceramic and metal can make the ceramic surface dirty. A small amount of concentrated sulfuric acid (hydrochloric acid) can be used to clean it. ; If there is yellow dirt on the pump body, soak it in 10% oxalic acid for 5-10 minutes, and then rinse it with injection water. At the auxiliary nozzle of the air-jet loom, check whether the temple ring rotates flexibly, whether it is worn, whether there is accumulated flying debris, whether the distance between the yarn stop pin and the main drum is 0.5 mm, and whether the air pipe is leaking., whether there is oil leakage in the centralized oil supply, whether the oil pipe is damaged or bent, whether there is flying dust accumulated inside the control box, whether the height error of the heald frame is within 2 mm, whether the exhaust pipe of the air filter is smooth, whether there is any leakage on the warp beam pinion, There are flying flowers, whether there are yarn ends on the bevel gear shaft of the shedding device, whether the mesh on the oil filter is clogged, whether there are yarn ends rolled on the let-off and easing warp shafts, whether the wire insulation sleeves are damaged, and whether the brake clearance is correct. . Add oil to the oil nozzle, add oil to the tooth surface of the open gear and the chain, and check whether there is wear on the heald frame and heald frame guide plate.
⑸. The hardness of oxidation zirconium ceramics is greater than that of stainless steel. Contact between zirconium oxide ceramics and stainless steel can cause the stainless steel to adhere to the ceramic surface and cannot If removed, the filling pump may not operate smoothly or be unable to move. cause damage. It is recommended to use non-metallic materials as storage containers during cleaning and sterilization.
